Qidi Plus4 Dual Solid State Relay Bracket

Wanted a second relay to use with an AC heated bed conversion I was doing to the Qidi Plus4

Consult an electrician for wiring if you're not sure how to do it. 

Stock chamber heater to relay conversion:

• Red wires on the stock relay are Live so you attach those to the AC outputs of the SSR
• Blue heater wire goes to the black wire. WAGO's are great options. Both are neutral (heater is non polar, just how qidi had it)
• yellow is ground to earth, attach to the metal heatsink screws. 
• cut the white wire (I believe) with a JST on each end and terminate with ring or spade terminals to the + and - side of the relay
  • POLARITY IS IMPORTANT HERE. 

BOM:

• Used These Heatsinks
  • make sure to use the thermal paste and apply it on the metal bottom part of the relay
  • m4 hardware to mount relay to heatsink
• Used fan mount from original post, but re-uploaded it here
• LDO 3X2 Splicer Board
• 12X (Voron spec brass M3 heatset inserts M3X5X4)
  • 4X Mandatory, M4X8 can cut threads in the plastic
• 8X M3X8 Screws for heatsink, PCB, and fan mount mounting
• 4X M3X14 Screws for fan to fan mount
• 24V 4010 Axial Fan (if you did the 80mm mainboard fan upgrade, you can reuse the original fan here) 
• 2 M3 Screws reused from the stock plus4 relay housing to mount it to the plastic panel