Core One enclosure corner sealing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Parts to close the corners of the housing
- Ocena
- 5 / 5
- Polubienia
- 42
- Pobrania
- 107
- Wydruki
- 2
- Wyświetlenia
- 1550
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
In its original state, the upper corners of the Core One are very airy. To counteract this, I have attached additional parts on the inside to close the gaps. It is certainly not 100% tight but much better than without these parts. The parts are attached to the inside of the housing with 3 6x2x20 mm magnets.
Printing is possible without support.
Upfate: 20.06.2025
I have noticed that in the rear right corner the mounting of the part is only possible with some force due to the suspension of the “swing arm”. For this reason, I shortened the arms slightly in version 2 so that the part is easier to mount.