Core One enclosure corner sealing
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Parts to close the corners of the housing
- Rating
- 5 / 5
- Likes
- 42
- Downloads
- 107
- Makes
- 2
- Views
- 1,550
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
In its original state, the upper corners of the Core One are very airy. To counteract this, I have attached additional parts on the inside to close the gaps. It is certainly not 100% tight but much better than without these parts. The parts are attached to the inside of the housing with 3 6x2x20 mm magnets.
Printing is possible without support.
Upfate: 20.06.2025
I have noticed that in the rear right corner the mounting of the part is only possible with some force due to the suspension of the “swing arm”. For this reason, I shortened the arms slightly in version 2 so that the part is easier to mount.