1 / 7
TX16S Mark II Compact Rugged Box w/ Short Antenna Mount — zdjęcie 1
1 / 7

TX16S Mark II Compact Rugged Box w/ Short Antenna Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A rugged box with a carry handle for the transmitter in as small footprint as possible. Needs the short antenna mount.

Ocena
0 / 5
Polubienia
7
Pobrania
73
Wydruki
0
Wyświetlenia
372
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This case is printable on a 220x220 bed, longest side is 218.5mm so it just fits. Printed in PETG, about 250-300g total with 2 walls and 15% infill.

I realized there were no cases out there for the TX16S that I could find, part of that might be due to it being just too long to fit a case around it on a 220mm bed with the standard antenna mount. To solve this I designed a shorter antenna mount which cuts down the overall length of the transmitter by around 8mm. 

The antenna mount needs some supports to print well, it works well but has a small gap on the front side due to interference. I may come back and fix the design later on but I'll leave it for now. It fits the rubber gasket that can be removed from the original plastic piece.

The height of the case is made to fit with a small clearance to the gimbal protectors by Qrome: https://www.printables.com/model/61891-radiomaster-tx16s-gimbal-covers

The left side of the lid has protrusions which keeps the bottom of the transmitter from moving, and it fits snugly against the other sides. 

 

The case needs 4x M3x35 screws for the rear hinge and top of the latches, and 2x M3x40 for the bottom part of the latches which also acts as a hinge for the handle. 

 

The full f3d files for Fusion 360 is included, as well as a STEP files with the whole assembly and for the antenna mount. The design was inspired by the tool box by Yanev (link below) but the 90 degree corner on the bottom of the TX16S wouldn't fit very nice with the chamfered corners, so this model was built from the ground up instead. 

https://www.printables.com/model/39729-tool-box-parametric

 

Tagi