1 / 3
HeyGears Reflex RS RefleXtractor (Fume Extraction) for 3in/80mm Hose — zdjęcie 1
1 / 3

HeyGears Reflex RS RefleXtractor (Fume Extraction) for 3in/80mm Hose

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

3in/80mm fume extraction hose adapter for HeyGears Reflex RS printer

Ocena
0 / 5
Polubienia
9
Pobrania
75
Wydruki
0
Wyświetlenia
392
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a remix of the Heygears Reflex RS RefleXtractor by @Jerry_Lee to make use of 3in/80mm diameter hoses.

The model was remixed to be smaller, easier to fit on most print beds, and printable in one piece. A few fitment tweaks were made too.

This will let you open the printer almost all of the way, but it's inevitable that a 3in hose will get in the way. You could try to make the model even taller to avoid the door hitting the hose, but then that would be a hassle, if not impossible, to print so this was the best compromise. See picture for example.

Should be printed upside-down (curved side down, it should import that way) with support only necessary from build plate only. Printed on a Bambulab X1C at Extra Draft quality setting (0.28mm layer height) with no issue.

Thanks to @Jerry_Lee for the awesome fume extraction idea!

Tagi