Autodarts Dart Camera Setup V3 / USER MANUAL / Darts (joint plug-in method)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Website: www.groni3d.com / Questions? WhatsApp at +49 163 8036832 or private Message.
- Ocena
- 4,87 / 5
- Polubienia
- 204
- Pobrania
- 3131
- Wydruki
- 33
- Wyświetlenia
- 15 060
- Oceny
- 23
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is my custom-designed Dart camera setup with an integrated light ring. I printed the whole setup on a Bambu Lab A1. The problem with other setups is that I hit the camera on top when trying to throw a double 20.
User manual
You can find a user manual in form of a PDF in the files. It will explain every step you need to make.
Contact
If anything doesn't fit or you have a problem, feel free to write a comment, send me a private message, or contact me via WhatsApp at +49 163 8036832 or E-Mail at [email protected] :)
If you enjoy the setup I would kindly ask you to upload a picture of your setup with a small feedback and rate the setup.
In the middle, there is a small bridge with a height of 0.2mm. You can use it to center the setup and mark the drilling holes. If you don't need it anymore, you can just break it off. It is also very stable thanks to the bracing on the back. So if you bump into the cameras, nothing will happen.
If you want the same setup when youre on the go check this out:
If you want the same NUMBER RING as me check this out:
Requirement / Dimensions / Components
Outer ring diameter: 745mm = 74,5cm
Farthest point from the wall: 375mm = 37,5cm
ca. 36h or 1d 12h print time (printed on Bambu Lab A1 and X2D)
1.370g filament
Printer bed size: 256x256 (length, width) tallest object: 190mm
Cylinder head screws:
12x DIN ISO 4762 M2x10
6x DIN ISO 4762 M4x16
6x M4 Thread inserts (NOT REQUIRED -> Component is in a separate folder)
Print settings
Layer height: 0.2mm (or smaller if you want more detail)
Support: Feet / Light feet / Case / Ring light left & right
Support settings: Tree auto / Threshold angle 30° / ✔ "Remove small overhangs"
Wall loops: min. 3
Infill: 7% to 10% with Grid or Gyroid (depends what you like more)
Seam position: aligned
Improvement from V1 to V2
Camera Position adjusted - LED strip position adjusted - Cable path adjusted - no ring joint visible from the front - length of the arms is shorter - tolerances adjusted