Scupper Transducer Mount & Passthrough (Pelican catch 110 & Garmin striker 4)

This model will allow you to pass through and mount a Garmin Striker 4 transducer to a Pelican Catch 110.

Credit to user_174422861 On Makerworld for the original model and creation

0.2mm layer, 2 walls, 80% infill

• PET-G
• Use supports for the bottom scupper mount
• Do not use support for the top mount
• Print at 80% for extra strength
• Use a nylock-type nut to avoid it backing off the bolt
• Use a stainless steel (rust) XX mm x 45mm machine bolt

1. Put the transducer wire through the big bell end of the bottom scupper mount and through the scupper in the kayak.
2. Put the wire through the small bell end of the top scupper
3. Mount the transducer at a 90 degrees to the screw.
4. Screw or push the screw end through the scupper from the bottom of the kayak
5. Screw the top down mount to secure the transducer - Tighten, but do not over-torque.