Simple Lithophane holder for Ikea "INGARED" desk lamp 110mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made a simple holder for round lithophanes for the INGARED desk lamp from Ikea
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 112
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Attribution — Share Alike
This is desgined to hold a round lithophane with an Ikea INGARED desk lamp. The inner diameter is 110mm so the lithophane should be a little smaller.
I made the lithophane itself on itslitho.com
If you use this service make sure to calculate the size correctly. If I got this right a lithophane with 100mm in diameter and 4mm thickness will result in a 108mm torus which should fit nicely.
I printed the parts from PETG. PLA could work as well as it doesn't seem to get very warm but I'd suggest to use something with a little bit higher melting point (PETG, ABS, HT PLA) just to be safe.
You will also need 6x M3x6mm screws. If you downsize the rings a little bit in Z-direction you can probably also use 4mm screws.
If you need the ring to be a different size, just let me know and I will happily adapt it to your needs. :)
As always: Drop me a message if you need changes or assistance.