1 / 1
10 Inch Rack Mount for Lenovo Thinkcentre M900 Tiny — zdjęcie 1

10 Inch Rack Mount for Lenovo Thinkcentre M900 Tiny

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Made my own mount specifically for the M900 Tiny version of the Lenovo Thinkcentre line.

Ocena
0 / 5
Polubienia
32
Pobrania
365
Wydruki
0
Wyświetlenia
2518
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution

Made a mount specific to the M900 version of the Lenovo Thinkcentre's. For some reason, this version of the mini pc had its feet rotated 90° so while existing models would have physically fit the chassis, the feet would have been in the way.

I also wanted a model that was A) Not made of perferations so it can print faster/more reliably, and B) Able to be securely locked in place, hence the holes at the back which like up with the chassis screw holes.

 

Print Instructions:  

  • 3 Perimeters minimum at 0.4mm nozzle
  • 0.25mm Layer heights
  • Print with the faceplate down (as loaded)
  • Preferrably PETG
  • At these instructions one mount weights around 130g of filament used.

 

Post Processing:

  • The model has some sacrificial bridging at the top to allow for the screw hole access and port clearance. Just clip the large part off with flush cutters, and nip the hole bridging so screws can pass through.

 

Optional Hardware:

  • Two M3x6 screws to secure the pc to the mount. You can get away with just one or none at all since the rubber feet make contact with the mount and gives good friction.

Tagi