Lid or cover for large pots, pans, other round container for e.g. sous-vide
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A large lid for a pot, pan or other round vessel with a section that allows a sous-vide stick through. Click-together.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 73
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a modular design for a fairly large lid (270 mm diameter) that clicks together from two positive (pins) and two negative (holes) sections. There is a positive section that accommodates a sous-vide stick (~80 mm diameter).
Printed with transparent PETG
Layer height: 0.22
Line width: 0.44
Walls: 4
Top shells: 4
Bottom shells: 4
Infill: Rectlinear 20%
This has worked fine for sous vide with temperatures up to around 70 c (158 f), but your mileage may vary. For temperatures at the higher end of sous vide, you may want to consider a more temperature-stable filament.
For me, the print worked fine in terms of clearance right away, i.e. the holes were quite tight for the pins, but with a bit of convincing it became a robust lid. If the fit is more slack, the lid may not be as sturdy.
It may be preferable to have it almost not fit until you clean off/shave off some material from the pins.