Motorised Air Duct Valve for 120mm Fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
An adapter that goes from a 120mm fan to a 100m ducting tube with a motorised flap inbetween controlled by a microservo (SG90).
For example code, please see Fume Extractor Controller.
Parts you'll need:
- 1 micro servo motor
- 1 m2 threaded rod
- 3 m2 nuts
- 2 m2x12mm bolts
- Arduino (or whatever you will be using to control the servo)
- 120mm fan
- Ducting Tube
Tools you'll need :
- Hacksaw
- Screwdriver
Instructions
- While printing assuming a 0.2mm layer height pause the print at layer 399 and insert the top m2 nut.
- Attach the servo to the adapter with the 2 m2 bolts
- Attach the valve to the servo
- Screw the m2 threaded rod through the valve and into the servo
- Put the m2 nut into the plug
- Screw the plug and m2 nut onto the rod
16/02/2025 V1: While browsing thingiverse I saw BKTRIES fan duct with rotating flap which interested me for my fume extractors. However it used a stepper motor which are expensive and require a specialty motherboard which I don't have space for in my controller box. Therefore I redesigned it to work with a servo motor which are cheaper and don't require an extra motherboard. I guesstimated the dimensions and spacing of the servo and designed the part.
23/02/2025 V1.1: Moved motor hole by 1mm to fit servo properly.
05/05/2025 V1.2: Edited valve end to fit the servo cog properly using JayPods Design. Edited adatper to fit the new valve. Added twist lock holes to adapter and adjusted size (100mm to 90mm) to work with Justales twist lock because I thought that would be cool. Added hole for locking nut into the plug. I might change the valve, it may be too heavy for the servo to move at the moment due to its thickness.
23/05/2025 V1.3: Increased diameter of adapter from 90mm to 91.5 for a tight fit on the twist lock. Increased the diameter of the valve from 83mm to 84.5mm.
28/05/2025 V1.4: Increased height of twist lock catch from 3mm to 4.5mm.
28/06/2025 V1.4: Increased valve cog out diameter from 5.275mm to 5.5mm as this size didn't fit on the servo. Added chamfer to plug m2 nut hole for stringless printing.
Print Settings
Printer Brand:
Creality
Printer:
Ender-3 S1
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
20
Notes:
Use supports on adapter.
Assuming a 0.2mm layer height while printing the adapter, pause the print at layer 399 to insert the m2 nut.
Category: DIY