FMS Ranger 1220mm Wing Strut
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement wing strut for the FMS Ranger (1220mm). Slightly changed from OEM to make it easier to print.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 189
- Wydruki
- 1
- Wyświetlenia
- 458
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
Replacement wing strut for the FMS Ranger 1220mm. This is nearly the same as the OEM strut save for a small flat spot that should be oriented down towards the bed.
Supports are necessary for the two small protrusions that connect to the fuselage and the wing. The strut should be printed in this orientation for maximum strength.
Infill can be as low as your printer can reliably print, but I recommend at least 3 walls (1.2mm) and 5 top/bottom layers (1mm)
As designed the strut is for the left wing. Simply mirror it for a full set.