2020 Extrusion Panel mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This panel mount allows Plexiglas panels or other panel materials to be mounted within 2020 aluminum extrusion frames.…
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 52
- Wydruki
- 0
- Wyświetlenia
- 1416
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This panel mount allows Plexiglas panels or other panel materials to be mounted within 2020 aluminum extrusion frames. I used them to add a panel to the bottom of my HyperCube printer. The mounts provide the advantage of placing the mounting hole well away from the edge and putting gentle pressure on a wider area rather than a concentrated screw hole so that cracking is less likely . Using these mounts also makes the panel easy to remove without internal access.
To use these panel mounts, drill a 6 mm hole in the panel 12 mm from the edge. Attach the mount with the bushing and a 3 mm x 8 mm screw and washer. Use a 5 mm screw and extrusion T-Nut to mount the other end to your 2020 extrusion. The bushing hole is self tapping.
The mount is designed for 3 mm thick panels but can be used with thicker panels. For thinner panels, you may need to shorten the bushing.
This is the HyperCube Printer I am using these panel mounts on. http://www.thingiverse.com/make:272257
Print Settings
Printer:
HyperCube
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
50%
Notes:
PLA is fine, ABS even better
Category: 3D Printer Accessories