tp-link omada EAP620 side mount for 10 inch rack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A side mount for the eap620 to fit the 10 inch rack
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 252
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I was making the 10 inch rack in 5u variant and wanted to mount a eap620 to the side for a all inclusive network i was building. it may fit other models as long as the spacing is about 53-54mm from outside to outside for mount holes on mount plate
My printer is not big enough to print it all in one, so I had to split the model up. I have attached the full model and both halves.
The hardware i used to put it together 1 was a m5 heat set thread and 35mm screw to lock the top over the handle bottom rail.
3x m3 heat set threads 1 to attach the 2 halves together and 2 used for the eap mount
note: the pic of the feet on the bottom rail has been adjusted in the model so they should sit on the bottom rail now for a better fit.
Print Settings
Supports:
No.
Resolution:
0.2 or 0.24
Walls/Perimeters:
At least 3.
Infill:
15% or more.
Filament:
PLA+/PETG/ABS/ASA/PC/Nylon