Nozzles for Loctite 30ml glue tubes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Nozzles for Loctite 30ml Vinyl, Fabric & Plastic glue tubes
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 103
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
UPDATE: I compared the strength of this Loctite glue against Bostik “Hard plastic” glue. Check out my other model uploads for “Glue tensile strength test object” for a brief summary of my test results. Spoiler alert, the Bostik glue tested a lot stronger than the Loctite glue. I still feel that the Loctite glue is sufficient for general assembly of models printed from PLA.
<<<<<<<<<<<<<<<<<<<<<>>>>>>>>>>>>>>>>>>>>>>>>>>
Nozzles for Loctite 30ml Vinyl, Fabric & Plastic glue tubes.
May also suit other tubes of glue, grease, etc.
4x different diameter outlet tips- 1mm, 1.5mm, 2.0mm, 2.5mm.
I'm not exactly sure what thread was used on this tube, but the closest suitable match I found was M12. I've included 2 different thread pitches for each nozzle- M12x1.0mm, and M12x1.25mm. The M12x1.0mm thread feels like the better choice on this particular tube, but I also made a 1.25mm pitch version too.
Each nozzle has the outlet diameter and thread pitch marked on it.
I print these at 0.1mm layer height to help keep the thread smooth, and with 2 perimeters, 15% gyroid infill, no supports or brim. They don't require much filament, so they're a good way to use up short pieces of leftover filament. I treat each nozzle as disposable and “single use only”.
If anyone Aussie's want to buy this glue, it's available from Bunnings.