WinWing Joystick/Throttle HOTAS mount for 15.5 mm thick desk

Lets you removably mount the WinWing Orion 2 HOTAS system to a 15.5 mm thick desk.

The joystick mount is printed in two parts, which can be joined using a 3mx20 screw and/or glue.  The throttle mount requires two hex nuts and 3mx20 screws, sandwiching the rear flange between the Throttle Bottom Plate and Top bracket.

The Desk Attachments should be printed with PETG, or possibly ABS if you want it firmer.

Insert slide the joystick and throttle into place, and insert the Desk Attachments to determine where to drill the screws to hold the Desk Attachments in place.

Once the Desk Attachments are mounted, you can slide them into place.  If it's too jiggly, you can print and insert the “key” into the opposite side exposed slot to lock the flexy bits in place.

Vid: https://www.reddit.com/r/functionalprint/comments/1lsfkdk/

Besides the Desk Attachments in PETG 20% infill, I printed the rest in PLA 15% infill.

I included the STEP file, so you can modify the height to accommodate thinner or thicker desks.


Edit: After a friend pulled up too hard, the original made a large cracking sound.  So I made a new version with clamps on both sides for the joystick.  I also made a new small piece to clip onto the front right of the throttle to hold the front part down.  I also made wall mounts to hang them