Vanderhall Glovebox Knob fits over key
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a knob that slides over your glovebox key to hide the key and create a better looking knob that can be left in
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 58
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a knob that slides over your glovebox key to hide the key and create a better looking knob that can be left in place. I printed mine in PETG. I pushed my key into it right after it was printed. It was a tight fit for the key. I used pliers to push it all the way in. It required a little pit of working side to side. If you have issues pushing your key in then I suggest heating the knob some with a hair dryer or heat gun right towards the slot the key pushes in.
I printed this on a Bambu Lab P1S I also used adaptive layer height to better handle the radiuses.
I printed this with the opening facing down and I used supports.
You could also sand and paint the knob for a better appearance. This fits my CompX National Key C346A