Liczymy pasujące modele…
These are Visors for the gauges on a Vanderhall Carmel. I printed them with PETG. They are a snug slip on fit. If they loosen up over time you may need to add double sided tape. If it is too tight to slide over you can heat the bottom…
These are Visors for the gauges on a Vanderhall Venice. I printed them with PETG. They are a snug slip on fit. If they loosen up over time you may need to add double sided tape. If it is too tight to slide over you can heat the bottom…
These are Visors for the gauges on a Vanderhall Carmel. I printed them with PETG. They are a snug slip on fit. If they loosen up over time you may need to add double sided tape. If it is too tight to slide over you can heat the bottom…
Vanderhall Carmel 3rd Brake light housing – This 3D Print file will only fit the Carmel model with the larger roll bar diameter not the Venice. It is designed to accept a standard Vanderhall brake light (Not included) to match the other…
This is a knob that slides over your glovebox key to hide the key and create a better looking knob that can be left in place. I printed mine in PETG. I pushed my key into it right after it was printed. It was a tight fit for the key. I…
for best results, print 2 in TPU or another squishy material and flip 1 before installation . If you have any questions or helpful suggestions, please comment and I will get back to you at some point.
This knob that slides over your glovebox key (Which must be cut down) to hide the key and create a better looking knob that can be left in place. I printed mine in PETG. If your cut down key is loose you can glue the key in or just wrap…
I made this mount so that I could be seen from higher up. print in a material that can stand up to the outdoors. If you have any questions or helpful suggestions, please comment and I will get back to you at some point.
Vanderhall Carmel Cup Holder Adapter – 3D print STL for a cup holder adapter slides into the existing small cup holder and offsets towards the inside of the vehicle a new larger cup, tumbler or flask holder with a hole size of 3.44 inches…
These are cone tail light overlays that can be slid onto the Vanderhall Carmel or Venice tail lights. use a strip of double sided tape inside on the cone. Then push straight onto your taillight. I printed these with Transparent Red PETG…
