1 / 3
Bosch PS21 (GRS12V or GRS10.8V) Lithium Ion Bit Holder for Drill Driver — zdjęcie 1
1 / 3

Bosch PS21 (GRS12V or GRS10.8V) Lithium Ion Bit Holder for Drill Driver

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This bit holder attaches without screws and uses NO MAGNETS due to the excellent design of the friction fit hex cutouts.

Ocena
0 / 5
Polubienia
1
Pobrania
15
Wydruki
0
Wyświetlenia
141
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I scoured all the major model sites for bit holder for my beloved Bosch PS21 Driver. I printed out a bunch, but many were not the same drill model, or required magnets to be glued during the printer or after.  The original model that this remix is based upon was probably for a different drill as it was about 5mm too loose (overall width) but had a wonderfully designed friction fit for bits.  Using the great friction fit of the original and great fit on the back of the drill of the Bosch Blue holder on MakerWorld (that required magenets), I made the perfect FrankenBit holder.  It can most likely be used for those with GSR12V or GSR10.8 Bosch Drill Drivers.  My drill model is shown in Pic#2.  Perfect fit on drill and perfect friction hold on bits.  No magnets.   

Tagi