1 / 2
Motorcycle Brake Line Holder for 50mm forks — zdjęcie 1
1 / 2

Motorcycle Brake Line Holder for 50mm forks

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

2 piece clamp that holds your brake line snug to the bike, looks neat and keeps them out of the way

Ocena
0 / 5
Polubienia
5
Pobrania
25
Wydruki
0
Wyświetlenia
154
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial

Had custom stainless lines made for my vintage Kawasaki H1 500, along with different brakes that use a traditional banjo. Several ideas for keeping the line close, but this seemed fun to make. 

Updated this model. Marked it as V2, but it is more just a different option than much of an improvement. Set the brake retainer toward teh bottom so no supports are needed, and made a left/right version with more accessible screw pockets. 

Second time around I am using PC-PBT, and I know a bit more to suggest increasing walls for a solid part vs infill, but either way you should be good to go. 

There are two piece in one STL file. 

I used Sunlu PETG .2mm 100% infill. 

M4 hex socket cap screws and M4 nuts, two of each. The one for the brake retainer clip can be smaller. 

Tagi