Motorcycle Brake Line Holder for 50mm forks
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
2 piece clamp that holds your brake line snug to the bike, looks neat and keeps them out of the way
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 25
- Makes
- 0
- Views
- 154
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial
Had custom stainless lines made for my vintage Kawasaki H1 500, along with different brakes that use a traditional banjo. Several ideas for keeping the line close, but this seemed fun to make.
Updated this model. Marked it as V2, but it is more just a different option than much of an improvement. Set the brake retainer toward teh bottom so no supports are needed, and made a left/right version with more accessible screw pockets.
Second time around I am using PC-PBT, and I know a bit more to suggest increasing walls for a solid part vs infill, but either way you should be good to go.
There are two piece in one STL file.
I used Sunlu PETG .2mm 100% infill.
M4 hex socket cap screws and M4 nuts, two of each. The one for the brake retainer clip can be smaller.