1 / 2
Mitsubishi Pajero/Montero/Shogun brake fluid reservoir cap — zdjęcie 1
1 / 2

Mitsubishi Pajero/Montero/Shogun brake fluid reservoir cap

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a temporary replacement cap for the brake fluid reservoir on a Mitsubishi Pajero 4th generation (Montero/Shogun)

Ocena
0 / 5
Polubienia
5
Pobrania
89
Wydruki
0
Wyświetlenia
373
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution

This is a temporary replacement cap for the brake fluid reservoir on a Mitsubishi Pajero 4th generation (Montero/Shogun).

I suspect this would work for other Mitsubishi cars.

I have made this out of ASA, however I believe that brake fluid (DOT3/4) would corrode ASA, PETG and PLA. Perhaps ABS might be better. This should be used as a temporary measure only. 

The original cap also has a rubber seal on the inside, this stops moisture getting in, as brake fluid is hygroscopic. This replacement cap does not therefore seal completely the reservoir, hence it's only a temporary measure.

 

Printed with 20% infill

0.2mm layer height

4 perimeters

Supports (standard) were used (they are easy to remove) to assist with printing the 3 tabs properly.

Tagi