1 / 8
Prusa MKxx Spool Holder with Single 608 Bearing — zdjęcie 1
1 / 8

Prusa MKxx Spool Holder with Single 608 Bearing

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Only one single 608 bearing needed. Replaces the stock spool holders. Just twist them on like the originals.

Ocena
5 / 5
Polubienia
28
Pobrania
66
Wydruki
3
Wyświetlenia
477
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Prusa MKxx Spool Holder with Single 608 Bearing

 

My MK4S came with a spoolholder. The spools do not run smoothly on them.
Especially when printing TPU (which the MK4S' nextruder is terrible at) requires as little friction as possible.
I reverse-engineered the existing twist-lock connector. It fits perfectly.

The structurally important parts are printed flat (bearing housing and 8mm axle). This prevents breaking along layer lines.

Tip: Before printing the whole thing, make tests. Cut the relevant pieces and make a test print. It is crucial, that the bearing fits snug in the bearing case. And the 8mm axle should have a tight fit in the bearing hole. Also the AxleClampNut should fit well on the axle.
Adjust X-Y-hole compensation and X-Y-contour compenstion if necessary.
You can also use teflon tape on the axle if the fit is too loose.


Hardware requirements

  • 1x M3 25mm Hex Screw
  • 1x M3 Hex Nut
  • 4x M2 10mm Hex Screws
  • 4x M2 Hex Nuts
  • 608 Bearing (of good quality)

 

Here's an animation on how it goes together:
Explosion Animation

Have fun assembling it!

If you like the design, please add a make and comment and rate it!
I spent 4h on this. I provide the step files since stls seem to be less accurate.

Thanks!

 

Tagi