Prusa MKxx Spool Holder with Single 608 Bearing
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Only one single 608 bearing needed. Replaces the stock spool holders. Just twist them on like the originals.
- Rating
- 5 / 5
- Likes
- 27
- Downloads
- 66
- Makes
- 3
- Views
- 475
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Prusa MKxx Spool Holder with Single 608 Bearing
My MK4S came with a spoolholder. The spools do not run smoothly on them.
Especially when printing TPU (which the MK4S' nextruder is terrible at) requires as little friction as possible.
I reverse-engineered the existing twist-lock connector. It fits perfectly.
The structurally important parts are printed flat (bearing housing and 8mm axle). This prevents breaking along layer lines.
Tip: Before printing the whole thing, make tests. Cut the relevant pieces and make a test print. It is crucial, that the bearing fits snug in the bearing case. And the 8mm axle should have a tight fit in the bearing hole. Also the AxleClampNut should fit well on the axle.
Adjust X-Y-hole compensation and X-Y-contour compenstion if necessary.
You can also use teflon tape on the axle if the fit is too loose.
Hardware requirements
- 1x M3 25mm Hex Screw
- 1x M3 Hex Nut
- 4x M2 10mm Hex Screws
- 4x M2 Hex Nuts
- 608 Bearing (of good quality)
Here's an animation on how it goes together:
Explosion Animation
Have fun assembling it!
If you like the design, please add a make and comment and rate it!
I spent 4h on this. I provide the step files since stls seem to be less accurate.
Thanks!