TP-Link Omada EAP610, 613, 620HD, 650, 653, 653UR Access Point 10-in Rack, 2U Mounting Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 2U 10-inch rack mounting bracket for certain TP-Link Omada Access Points.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 496
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
A 2U 10-in Rack Mounting Bracket for the TP-Link Omada EAP610, 613, 620HD, 650, 653, 653UR Access Points.
Print the cross-bar and 2 plates. Secure the plates to both sides of the rack, drop M6 hex nuts into the slots in the cross-bar, and secure the cross-bar to the plates on either side. You will likely want to install this first before loading up the remainder of the rack.
If you are mounting this in the Skeleten, make sure you install the top plates to the rack before installing the AP. The AP leaves very little room to hold the hex nuts while you install the top plates in the rack.
I designed and printed the Skeleten, a 10-inch rack to house my homelab. I wanted it to contain everything I needed, except maybe a NAS.
From top to bottom:
2U - Vented TP-Link EAP610 WiFi AP Bracket
1U - Beelink EQ14 (pfSense firewall)
1U - Patch panel from Amazon
1U - Sodola 8x2.5G + 1x10G SFP Switch Bracket
1U - Minisforum GK41 Bracket (low power Proxmox node)
1U - EliteDesk G3/G4/G5 Bracket (additional Proxmox nodes; one is a G3, one is a G5, both fit the same bracket.
1U - EliteDesk G3/G4/G5 Bracket (additional Proxmox nodes; one is a G3, one is a G5, both fit the same bracket.
1U - Vented blank
1U - Solid blank
TP-Link Omada EAP610, 613, 620HD, 650, 653, 653UR Access Point Mounting Bracket
This bracket has a cross-bar that allows you to mount the mounting plate that comes with the AP to the cross-bar. The cross-bar is then secured to the rack using 2U vented face plates. Everything is designed for M6 x 20mm screws and M6 hexnuts. I used brass M3 heat-set threaded inserts to mount the plate but small M3 screws will also work.
