1 / 4
Clik pump head to Inf-2 adapter
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 3d printable adapter that allows Inf-2 units to inflate and give accurate pressure readings for Schwalbe Clik valves
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 27
- Wydruki
- 1
- Wyświetlenia
- 303
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial
Converts the presta side of the dual sided head of a Park Tool Inf-2 to a Schwalbe Clik head. There are two versions currently available:
- V3 model uses assembled valve converter for easy use and installation, this model does not always create a perfect seal but valve converter is removable.
- V4 model uses disassembled valve converter for better sealing capability and robustness, this model creates a perfect seal but cannot be easily removed from valve converter.
Uses a Schwalbe Clik Valve Conversion Set (NOT COMPATIBLE WITH PUMP HEAD KIT
Also requires:
- Park Tool Inf-2
- 8mm hex wrench
- PTFE Thread tape
- 17mm Spanner (or adjustable)
- Super glue (V4 only)
Installation instructions refer to park tool exploded diagram
V3 Directions:
- Print adapter at 100% infill, min 5 perimiters, max 0.2mm layer height out of a robust material
- Remove Presta Cap (13) from Inf-2 using 8mm hex
- Apply many layers (variable) of PTFE tape to printed adapter exterior threads
- Screw printed adapter into fill head (15) tightly by hand
- Apply ~3 layers of PTFE tape to Schwalbe pump adapter threads
- Screw Schwalbe pump adapter into printed adapter until snug
- If setup leaks in use, apply more tape
V4 Directions:
- Print adapter at 100% infill, min 5 perimiters, max 0.2mm layer height out of a robust material
- Disassemble the schwalbe converter, exposing the ~14mm threads and rubber grommet on the head. Be careful not to loose the grommet as it is essential.
- Loosely screw the schwalbe head into the adapter with grommet to verify the print was successful, it should sit as shown in images snug to the printed adapter body.
- Unscrew the schwalbe head from the adapter and apply two small dots of superglue to the threads. Then re-screw as before ensuring the rubber grommet is in place. Allow to dry.
- Remove Presta Cap (13) from Inf-2 using 8mm hex
- Apply many layers (variable) of PTFE tape to printed adapter exterior threads
- Screw printed adapter into fill head (15) firmly with 17mm spanner
- If setup leaks in use, apply more tape
Results may vary due to the nature of 3d printed components.
If you require one of these but do not have a printer, feel free to contact me through printables.