Double Wide Rack Mount for Black Box Switches
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
19 inch rack mount conversion for Black Box brand desktop network switches. Requires removal from the OEM project box.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 43
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
Information
I needed a set of latching A/B switches for a fiber-based reflected memory that was mechanical, not remotely operated. There were very few rack-mounted options available, and they were disgustingly expensive. The Black Box brand switches were exactly what I needed, and could be found in new-old-stock, but were only available as desktop models. I designed this to be able to hold two of them in a standard 19" rack.
This is designed to be printed in three pieces, and can be arranged such that they can all be printed at a single time. I added integral supports so external supports won't be needed, but you will need to enable thin walls in most slicers to print them. The photo shows one that I modified for our labeling system, but the included file is blank. Printing on a textured sheet gives a nice finish, but printing on a smooth sheet will give you a better surface for labeling.
Assembly
To assemble, remove the built-in supports from the panel slots on the printed pieces. Remove the front and rear panels and the internals from the Black Box switches, and insert into either side of the center section with the support ribs to the bottom making sure not to stress any of the internal parts or kink any fiber lines. Slide the outer sides over the panels. Complete assembly with M3 screws and heated inserts.