50mm Tall Vented Riser with 4inch duct for Qidi Plus 4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a modification to the front left section of stews 50mm riser to allow the connection of a 4inch duct
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 512
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This replaces just the left section of stews riser and allows you to easily connect a 4inch duct. I've been using it to connect an extractor fan which then vents the air out of the window to try keep the room temp down. It seems to help so far and has been able to keep the chamber temp 5-10c lower than it was with just the lid propped open, this is with the extractor fan on and the right side vent open like seen in the pictures.
You will need 12 m3x30 or m3x25 screws to attach the coupler to the main body. The connection is for Juan Carlos Bodoque's magnetic coupler and takes the same magnets. There is also a shorter version of the inner ring that fits the coupler as the standard one is too long.
Supports are required for the 3 screw holes at the top of the front left section.
