Teyleten Robot ESP32 38 Pin Case with WLED Logo Side Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An ESP32 Case for Teyleten Robot's 38 pin version I designed in Fusion360 for running WLED in a lack enclosure.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 104
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
I could not find an ESP32 case that fit the specific ESP32 board that I purchased on amazon from Teyleten Robot so I designed one. The case is designed to fit the 38 pin version of this specific board:
https://www.amazon.com/dp/B09J95SMG7?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
The board is held up by the support ledge inside the case and no screws are necessary. The lid is the correct height to hold the board in place when on. There is a tiny support that needs to be removed from where the back of the ESP32 board goes into the case that should come off easily with a small flathead screwdriver. The lid is a tight fit so you may want to scale it down by a percent or two.
I included the WLED Logo which I cut out from trial_attorny's model on printables (https://www.printables.com/model/849239-esp32-case-wled-logo-lid-remix/files). If you want to print the lid with the WLED log inlayed in a different color like in my photo, scale the z height of the logo to 0.4mm and follow this guide:
https://www.youtube.com/watch?v=m_SXRGGoTQo