Primitive AMS desiccant box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple desiccant box for AMS that can be easily replaced without removing the spools. Only 15 g and about 45 minutes
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 75
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This summer is very humid and I don't want to unload AMS to replace desiccant beads. These can be replaced with spools loaded and have tab for handling.
Holds about 50 g of silica gel beads. About 1 mm width slits.
2 pieces print in about 1.5 hours. I use no top & bottom layers, set first layer and sparse infill width to 0.5 mm and 40% grid infill (Orca slicer) and that gives size net. Minimal speed for filament is 10 mm/s with 100% cooling for bridges. Outer wall width in my case was 0.9 mm with 0.4 mm nozzle and 0.3 mm layer height.
Lids are designed without any allowance and mine required light filing at one end (due to filament bulging). Filing is not necessary thought, they would just fit a bit tighter.