1 / 5
Subaru Forester SG 06-08 Foglight Air Ducts — zdjęcie 1
1 / 5

Subaru Forester SG 06-08 Foglight Air Ducts

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Air ducts to replace the 06, 07, 08 SG subaru forester's factory foglights on the front bumper

Ocena
0 / 5
Polubienia
11
Pobrania
36
Wydruki
0
Wyświetlenia
510
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This model is a replacement for the stock foglights on 2006, 2007, 2008 SG Subaru Foresters. I made them for my track-ready forester so that I can plumb brake ducting to the front rotors.

These fit into the factory foglight mount points. You'll need to use one panhead screw (or a screw with a washer) where the pre-made hole is. You should even be able to re-use the one you'll have after removing the stock foglights.

Fits 3" air ducting hose.

Print instructions:

  • Mirror the model in your favorite 3d printing model for the opposite side
  • Requires supports (I used tree mode which worked well)
  • I printed in PA6-CF just because. I'm sure ABS or ASA would work perfectly fine, too.

I suspect I may be the only person in the world to want/need/use these--if you happen to use them yourself, leave a comment so I feel better about not being the only crazy person racing a Forester XT as a track car.

Tagi