Logitech saitek yoke hall effect sensor upgrade
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Upgrade the original potenciometers to hall effect sensors
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 361
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
! IMPORTANT !
Logitech saitek 90° mod is required for this mod (https://www.thingiverse.com/thing:4596632)
I used SS495A hall effect sensor with a arduino pro micro (USB-C version)
The sensor is attached with a hotglue and it could be mooved a bit around the middle for fine manual calibration.
Also be cearful when glueing the magnets in place! One side should be south and other north (so the sensor goes from 0 - 500 - 1023)
D12 1mm neodymium magnets are used
The case fits the arduino, one button and two LEDs and 2 4pin JST-XH 2,54mm connectors (one is for the yoke and other is for a tiller)
I now have only the roll axis wired up, Ill post update when the pitch axis is done.
The arduino runs a simple code with the joystick.h lib, where it emulates joystick X axis with the mapped value.
The tiller is just a reserve for now.
Im open to any updates, this is very crude solution tbh, but for me it fixes the problem with the old pots.