Bulbasaur Phone Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A non basic 3d printed phone stand
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 272
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Sculptures
- Licencja
- Creative Commons — Attribution
I'm on a quest to make useful 3d models, first starting with Pokémon. I love to sculpt and 3d print, but I don't want to have a bunch of useless models lying around my house. This is my first of many useful designs that I'm working on.
If you want to see more, check out my YouTube @SpearmanWorkshop!
Leave a comment on what you want to see next!
Printing Advice:
I sized everything to 125% in OcraSlicer to get a good fit for my iPhone 11.
I printed the vines lying on their sides with 100% infill. The supports get a little messy on the vines and need to be sanded down, but with the layer lines running vertically, you increase the strength of them while they hold your phone.
For the base, I printed it at 8% infill.
Assembly Advice:
Yes, you're probably going to end up needing to sand down the vines a bit, but let's be honest, this is 3d printing, sanding is half the hobby.
As for gluing it together, that's up to you. I don't have mine glued together, and it works fine. By not gluing it, I am able to position the vines freely.