Braunability Remote Pendant Magnet Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mechanical way to add magnets to a Braunability pendant remote.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 43
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Medical Tools
- Licencja
- Creative Commons — Public Domain
We have a Braunability wheelchair lift in our van, and the insanely expensive pendant remote (more on that later) has a post-hanger-thing that has to go in one of 2 holes on the lift arm. The steel lift arm. Where you could stick the remote if it was magnetic, making it way easier to just set the remote down somewhere. I had some 20mm x 20mm x 6mm magnets laying around so I whipped this up. If your magnets are beefy like mine, 1 is sufficient, but if they're a little weenie or if you just want to be extra sure your remote won't fall, use 2.
Assembly is really easy, but you do it at your own risk - this is your warning that I take no responsibility if you mess up your remote, currently available online for $300-$400. That said, if you can handle any kind of 3d printer maintenance, you'll probably be fine. There are 4 screws on the front of the remote. Unscrew them (you can just leave the front plate in place), put a magnet or two in the side of this thing and put it in place on top of the front plate (mine kind of snapped in to position) and put the same 4 screws back, this time through the print. That's it.
Hopefully this can be of use to someone else.