1 / 6
Watercooling pressure test adapter g1/4 to schrader valve (bike/car valve) — zdjęcie 1
1 / 6

Watercooling pressure test adapter g1/4 to schrader valve (bike/car valve)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

An adapter fitting for testing if your loop can hold pressure, with a simple bike/car (schradervalve) pump with a guage.

Ocena
5 / 5
Polubienia
9
Pobrania
65
Wydruki
0
Wyświetlenia
248
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial

Did not wanna pay for an expensive pressure tester.. Made this and tried to make it easy to print. When I tested my loop with it, it held pressure for more than 15 minutes at 0.45 bars (~6.5 psi). Used the same type of O-ring that came with my other g1/4 fittings. 

Printing tips: 

Works with PLA, but PETG may hold better.

0.16mm layer hight may make the threads print better

Printing with a higher temperutare may make it hold pressure better.

Adding more wall loops may help it hold up better. 

Increasing infill may make it hold better. 

Tagi