Xshot MPP Motorized Piston Pump No Spin Buffer Tube Ring Clamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Prevents the buffer tube from spinning loose.
- Ocena
- 5 / 5
- Polubienia
- 22
- Pobrania
- 93
- Wydruki
- 4
- Wyświetlenia
- 708
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
It's my experince that 3D printed buffer tube rings, no matter how tight they were, always needed retightend after a couple of mags. Only accentuating the issue of the spinning buffertube due to the wear on the threads. This easy print has fixed the spinning buffer tube issue for me while preserving the threads.
Requires M3 hardware and the stock has to be removed to install. Whole process takes less than 10 minutes and saves a lot of trouble in the future.
Use channel lock pliers to tighten the original ring until the buffer tube doesn't spin. Careful not to over tighten or you will strip it. The clamp will slide over and compress around the ring a couple millimeters to create a rigid connection without stripping the plastic threads of the blaster.
*Printed in pla+. Untested with basic pla.*
Buffer tube Stock: https://www.printables.com/model/1372919-xshot-aeb-motorized-piston-pump-mpp-buffer-tube-st