1 / 2
Beamer adapter arm - for Optoma (and others)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Why I was printing the excellent beamer-to-tripod adapter made by Klenzel: https://www.thingiverse.com/thing:2638768…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 224
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Why
I was printing the excellent beamer-to-tripod adapter made by Klenzel: https://www.thingiverse.com/thing:2638768
However, the arms were too short to reach the M4 screwholes on my Optoma beamer. This bracket is designed to interface with his part, but increases the bracket length from 70mm to 94mm.
Features
- Interfaces with Klenzel's tripod beamer mount
- Tested with an Optoma beamer, should work with most beamers that have their mounting holes spaced a bit more distant.
- Takes M4 nuts and bolts
Instructions
- Print it with the flat side down
- .2mm is fine
- No supports needed
- Print slow and hot with plenty of walls/infill for optimal strength
- Beamers can get hot, so make sure you print in a temperature-resistant material just in case.
Open Source
As always the original design file (fusion360) is included, so feel free to improve it (or learn from it)!
Category: DIY