1 / 2
Beamer adapter arm - for Optoma (and others) — image 1
1 / 2

Beamer adapter arm - for Optoma (and others)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Why I was printing the excellent beamer-to-tripod adapter made by Klenzel: https://www.thingiverse.com/thing:2638768…

Rating
0 / 5
Likes
4
Downloads
25
Makes
0
Views
224
Reviews
0

Updated at source:

Model information

Category
Other Ideas
License
Creative Commons — Attribution — Noncommercial — Share Alike

Why

I was printing the excellent beamer-to-tripod adapter made by Klenzel: https://www.thingiverse.com/thing:2638768

However, the arms were too short to reach the M4 screwholes on my Optoma beamer. This bracket is designed to interface with his part, but increases the bracket length from 70mm to 94mm.

Features

  • Interfaces with Klenzel's tripod beamer mount
  • Tested with an Optoma beamer, should work with most beamers that have their mounting holes spaced a bit more distant.
  • Takes M4 nuts and bolts

Instructions

  • Print it with the flat side down
  • .2mm is fine
  • No supports needed
  • Print slow and hot with plenty of walls/infill for optimal strength
  • Beamers can get hot, so make sure you print in a temperature-resistant material just in case.

Open Source

As always the original design file (fusion360) is included, so feel free to improve it (or learn from it)!

Category: DIY

Tags