Beyblade / Bakuten Shoot: RC-launcher replacement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement parts for the launcher-part on RC-Beyblade remotes
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 424
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Ever had your plastic-gen RC shooter wear out so much that the winder started skipping during launch – and there were no replacement parts anywhere?
Not anymore!
This remake of the RC launcher unit is a perfect drop-in replacement.
Simply unscrew the old part from your remote, transfer all the other components from the original launcher into the printed one, close it up, and reattach it to your remote.
When it eventually wears down again, just print a new one – problem solved.
I had good results with printing the part in PETG, but if any other material seems to work better for you then go for it. The bottom-part also need supports to be printed.
Tip: If you’re using my printed ripcord with this launcher, it might feel a little tight when passing through.
If that happens, simply loosen the two screws attaching the launcher to the remote slightly – the ripcord will then run much smoother.