1 / 7
Low Support for Creality Display (K1 / K1 MAX / K1C / K1SE) — zdjęcie 1
1 / 7

Low Support for Creality Display (K1 / K1 MAX / K1C / K1SE)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The adapter model for moving the display to a lower position. For a door without a cutout.

Ocena
0 / 5
Polubienia
18
Pobrania
87
Wydruki
0
Wyświetlenia
841
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

The adapter model for moving the display to a lower position. For those who make a door on the K1SE or want to replace it with a door without a cutout (other K1 series).
After the modification, you will only have 6 mm between the floor and the display. If you are not satisfied with this, you can make boost pads or other legs for the printer (look for models on the website).
The best position of the part to print is in the photos. Hand-drawn organic supports are recommended to reduce time and material. It's recommended to set 3 perimeters and check in the table slicing so that the hooks are filled only with the perimeter lines.

Tagi