Off-Stamp Gen 2 X-Cube Vape Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two models, one for the larger vape and one for the smaller vape.
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 108
- Wydruki
- 1
- Wyświetlenia
- 563
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
No more dropping your vape and having your battery break off and fly across the floor!
There are three sizes for the newer Off-Stamp vapes. These sizes cover the Classic Cube, Sweet/Ice Cube, and Crystal Cube.
Model photos were printed in eSun PLA Tech Black. Tolerances are fairly snug, so account for shrinkage with other filaments. I uploaded a tester file to make sure it fits with your printer tolerances and filament; full scale to match the test print if needed. I printed this with and without supports. If you use supports, it will want to start supports in the inner hole of the model, so I added a small primitive object and allowed supports only on build plate to avoid that.
UPDATE: I renamed the files and added them to folders to make the vape type clearer. I added Strap and Loop files. These will be a tighter fit than the "Tester" because I changed the dimensions to follow the curvature better. The tester is still a good file for the full case because it follows the same inner dimensions.
I added a case remover. This printed with the correct tolerance with eSUN PLA, eSUN PLA Silk, and eSUN PLA+, but the eSUN PLA-Lite has a bit more shrinkage.
Printed in PLA with 0.2mm layer height on AnyCubic Kobra S1. Modeled with OnShape.