Off-Stamp Gen 2 X-Cube Vape Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Two models, one for the larger vape and one for the smaller vape.
- Rating
- 5 / 5
- Likes
- 14
- Downloads
- 108
- Makes
- 1
- Views
- 563
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
No more dropping your vape and having your battery break off and fly across the floor!
There are three sizes for the newer Off-Stamp vapes. These sizes cover the Classic Cube, Sweet/Ice Cube, and Crystal Cube.
Model photos were printed in eSun PLA Tech Black. Tolerances are fairly snug, so account for shrinkage with other filaments. I uploaded a tester file to make sure it fits with your printer tolerances and filament; full scale to match the test print if needed. I printed this with and without supports. If you use supports, it will want to start supports in the inner hole of the model, so I added a small primitive object and allowed supports only on build plate to avoid that.
UPDATE: I renamed the files and added them to folders to make the vape type clearer. I added Strap and Loop files. These will be a tighter fit than the "Tester" because I changed the dimensions to follow the curvature better. The tester is still a good file for the full case because it follows the same inner dimensions.
I added a case remover. This printed with the correct tolerance with eSUN PLA, eSUN PLA Silk, and eSUN PLA+, but the eSUN PLA-Lite has a bit more shrinkage.
Printed in PLA with 0.2mm layer height on AnyCubic Kobra S1. Modeled with OnShape.