1 / 3
SunLu 1kg and 3kg Spool Gridfinity Carousel Organizer — zdjęcie 1
1 / 3

SunLu 1kg and 3kg Spool Gridfinity Carousel Organizer

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Transform your old 1kg or 3kg SunLu spools into a gridfinity carousel.

Ocena
0 / 5
Polubienia
226
Pobrania
323
Wydruki
0
Wyświetlenia
3310
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Public Domain

Based on Zack Freeman's gridfinity system.

Uses M3 x 8 screws for the 3kg spool design, Uses M2 x 6 screws for 1kg spool design. and gridfinity 6x2mm magnets if you choose to use magnets. Uses a 3/4inch or 20mm rod for the middle. Or you can print the provided rod design. 

Printer specs: needs at least 180mm x 160mm x 100mm build volume. If you are printing the axel stick then you should have a 250mm build plate.

I have a bunch of SunLu spools lying and I wanted to use them for something. They use the older refillable spool design, I have not tested it with the newer spool design, so proceed with caution if you try to use the newer spool. 

1kg spool design: Can fit 9 1x1 bases. Superglue the 1kg spacer in the middle to shrink the hole diameter. Uses M2 x 6 screws. Fits 4 spools on the 306mm stick. Use 1 washer on each end and 1 in between each spool.

3kg spool design: can fit 6 2x2 bases. Superglue the 3kg spacer in the middle to shrink the hole diameter. Uses m3 x 8 screws. Fits 2 spools on the 306mm stick. Use 1 washer on each end and 2 in between the spools.

Tagi