Ryobi Charger 63mm Multiboard Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two pegs on separate panels, each for 3 Multiboard snaps to hang the charger with 63mm between mounting holes
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 213
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Share Alike
Two parts, one adds and one removes 6mm from the centerline. If you install them with 2 grid positions inbetween, there will be 75 - 12mm = 63mm between the pegs. You can also swap them around and get 75 + 12 = 87mm if you have a device with such mounting holes. Or any other combination of N 25mm +/- 12mm. Or you could print one of the options twice and have yourself (N * 25mm) distances.
They are pretty much impossible to orient in a good way on the printer, I ended up printing them upright - the same way they sit on the wall, which is not great. Needed some supports and definitely has some weak parts. But it holds just fine nonetheless!