1 / 2
Sunton ESP32S3 4.3" IPS Outdoor Case 8048s043c
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an outdoor case I'm using for my sunton panel as a keypad
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 164
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a case I made to incorporate my 4.3" display as a keypad on my gate outdoors.
It has a big “belly” so you can have your necessary components inside.
I have:
- LM2596 buck converter on top
- 3.7V battery, small BMS with 5V output, PNP transistor to be able to drive Relay with LOW (needed because it boots with both RXD and TXD as HIGH in bootloader), Wagos in center
- Relay in bottom
Install:
- The outer screw holes are to fix case-down to the wall
- The inner screw holes are to fix case-up to case-down
- Have all the internals set up first and have the 5V-RXD-TXD-GND5V-RXD-TXD-GND cable ready to be connected to screen.
- I advise pushing the screen into case-up first, connect the 5V-RXD-TXD-GND cable to the screen, then push case-up in place, secure with M3 bolts