A4T-AFC Cutter Arm Base for Titanium Backers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The original base design would've required me to remove my titanium backers from my Y axis, this model solves that issue
- Ocena
- 5 / 5
- Polubienia
- 24
- Pobrania
- 70
- Wydruki
- 1
- Wyświetlenia
- 628
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
I recently switched to the A4T tool head with AFC and had to remove my backers to install the cutting bar base. I immediately saw my bed mesh get worse, so I designed this to allow me to run both. I'm probably going to make another model with the mount for the cutter arm between the screw holes instead of offset to one end like this one, just for more possibilities when mounting. If this is something anyone is interested in, leave a comment and I'll whip one out real quick.
NOTE: Because this is being used with backers, the screw size was reduced from M5 to M3. I made the holes for the screws intentionally tight to spread the clamping force out as much as possible. You will have to thread the screws into the base and strip the threads it creates in the plastic to open the holes up just enough to then install. Alternatively, you could use a washer under the head of the bolt, but I didn't have any on hand.