1 / 4
Taylor 1476N // 1476N9 // 1476 Thermometer Probe Swivel Repair — zdjęcie 1
1 / 4

Taylor 1476N // 1476N9 // 1476 Thermometer Probe Swivel Repair

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Fixed my 1476N Taylor thermometer that is designed to break. I tried to make the end stronger to make it last longer.

Ocena
5 / 5
Polubienia
1
Pobrania
7
Wydruki
1
Wyświetlenia
34
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

Fixed my 1476N Taylor thermometer that is designed to break. I tried to make the end stronger to make it last longer. Printed in PETG and it's holding up fine. The original part is ABS, I would print it in that material if I could.

You have to DESOLDER the thermistor which is 2 wires on the board to put on the new part then resolder the wires. The case is split in half, so you'll have to pry it open down the middle and there's a screw holding the swivel on.

Print the part with the hole for the probe pointing up so you won't have to remove supports generated in the hole which are hard to remove. I believe it takes around 40 minutes to print in that orientation. I think I used 30% infill.

If you want to modify it, I uploaded the f3d file but just warning you that I am a noob and my file/design is messy.

Tagi