1 / 4
Taylor 1476N // 1476N9 // 1476 Thermometer Probe Swivel Repair — image 1
1 / 4

Taylor 1476N // 1476N9 // 1476 Thermometer Probe Swivel Repair

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Fixed my 1476N Taylor thermometer that is designed to break. I tried to make the end stronger to make it last longer.

Rating
5 / 5
Likes
1
Downloads
7
Makes
1
Views
35
Reviews
1

Updated at source:

Model information

License
Creative Commons — Public Domain

Fixed my 1476N Taylor thermometer that is designed to break. I tried to make the end stronger to make it last longer. Printed in PETG and it's holding up fine. The original part is ABS, I would print it in that material if I could.

You have to DESOLDER the thermistor which is 2 wires on the board to put on the new part then resolder the wires. The case is split in half, so you'll have to pry it open down the middle and there's a screw holding the swivel on.

Print the part with the hole for the probe pointing up so you won't have to remove supports generated in the hole which are hard to remove. I believe it takes around 40 minutes to print in that orientation. I think I used 30% infill.

If you want to modify it, I uploaded the f3d file but just warning you that I am a noob and my file/design is messy.

Tags