EKIY MTC-14 (L300) navigation bar mount

Navigation bar mount for EKIY MTC-14 (same as EKIY L300) Carplay / Android Auto head unit.

You can use it to attach head unit to 22mm navigation bar or handlebar of the same size.

You would need following fasteners:

• 4x M3x5 or M3x6 heat inserts;
• 4x M3x20 non-countersunk screws.

I've used PETG-CF due to added stiffness & resistance to elements. ABS, ABS-CF, ASA, ASA-CF, PA12-CF would also do well. Avoid PA6 & PLA due to susceptance to moisture. 

Assembly is straightforward:

• print clamp and base parts;
• install heat inserts from the bottom plate side of base part;
• install rubber bushings from original ball mount to the base part;
• fix base part to the head unit (longer bracket side goes to the top side of head unit, see attached photos) with screws from original mount;
• attach and tighten clamp with two screws at the top, orienting the thicker part to the top - so there is a gap below the bar to allow clamp tightening;
• use another two screws at the bottom holes to clamp whole assembly on the navigation bar;
• connect head unit wiring according to user manual & your preference, use acetate cloth electrical tape to wrap wires & fix them on a bike.

If you live in Russia, you can order this mount from me pre-printed and pre-assembled via Avito:
Кронштейн для мотонавигатора EKIY MTC-14 / L300