Voron Turtle Purge Bucket nozzle scrub catcher with build plate stops
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I really couldn't find the exact purge bucket I wanted for my Voron 2.4 350 from LDO kit. So I made this one.
- Ocena
- 5 / 5
- Polubienia
- 35
- Pobrania
- 142
- Wydruki
- 2
- Wyświetlenia
- 942
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
I am in the process of prepping the printer for Filamatrix and BoxTurtle, and I wanted a scrub brush that went up and down with the gantry and a BUCKET to catch the droppings from higher up…. Couldn't find one I liked so I made this one. My printer is a 350mm and this may or may not fit in smaller printers depending on if Klicky is there, etc.
I also wanted stops to align the PEI build sheet better/easier as I never had them, so integrated that in….
Am using this gantry mounted brush system which I like so far…. AFC-Accessories/AT_Brush/ReadMe.md at main · ArmoredTurtle/AFC-Accessories · GitHub
Will see how I like it once the other pieces are in place but working great as is. Make sure the nozzle scrub does not crash into the Stop screws… including my nozzle_scrub.cfg (rename txt to cfg) as-is for example noting it is not fully cleaned up from where I started but works fine for me.
Right now I am using Klicky, but wanted it to be ready if I decide to go to Cartographer and the silicon brush helps here.
Print settings can be Voron norms…. 0.2 layer height, 4 perimeters, 4 top/bottom layers, no supports.
Am using about (4) 6mm x 3 Magnets and about (6) 3mm x 8 SHCS along with (4) 3mm maker bar nuts.
Of course, you can mirror the parts in the slicer if you want to make a ‘right handed’ one.